Technicians on call now · Schertz, Cibolo & Universal City Furnace & heating repair · Written price before work
Homeowner guide

Furnace filter guide for South Texas homes

The cheapest furnace part is also one of the most important. A clogged filter causes overheating, short cycling and blower strain. Here's how to choose it, install it and know when to change it.

Quick answer

Change a standard 1-inch filter every 1–3 months, and monthly during heavy use, with pets, or during mountain cedar season (about December–February). Thicker 4–5 inch media filters often last 6–12 months. Install it with the airflow arrow pointing toward the furnace. A MERV 8–11 filter suits most homes; higher MERV only if your system can handle the airflow restriction.

How often to change it

Situation 1-inch filter 4–5 inch media filter
Typical home, no pets Every 2–3 months 6–12 months
Pets or allergies Every 1–2 months 4–6 months
Cedar season, dusty construction nearby Monthly Check every 2–3 months

Remember that in most Schertz homes the same filter serves the AC all summer, so it works year-round, not just in winter.

Why South Texas changes the schedule

  • Mountain cedar pollen peaks in Central Texas from about December through February, right in heating season, and loads filters fast.
  • Year-round use: the blower runs for heating and cooling, so filters see far more hours than in milder-summer climates.
  • Construction dust in growing areas like Schertz and Cibolo clogs filters quickly.

Which way does the filter go?

Look for the arrow printed on the filter frame. It shows the direction of airflow and should point toward the furnace (away from the return grille). In a wall or ceiling return grille, the arrow points into the wall or ceiling, toward the ductwork. At the furnace itself, it points into the unit.

Choosing a MERV rating

MERV 1–4

Basic fiberglass. Protects the equipment, but does little for air quality.

MERV 8–11

The sweet spot for most homes: captures pollen, dust and pet dander without straining most systems.

MERV 13

Better for allergies and fine particles. Best in systems designed for it, often with a 4–5 inch media cabinet.

MERV 14+

Usually too restrictive for residential furnaces unless the system is specifically designed for it.

Higher isn't always better. A very restrictive 1-inch filter can choke airflow, causing overheating and limit-switch shutdowns, much like a dirty filter. If you want better filtration, ask about a 4–5 inch media cabinet.

Signs your filter is the problem

  • The furnace shuts off mid-cycle and the blower keeps running (limit trips)
  • Weak airflow from the vents
  • Short cycling (learn more)
  • More dust in the house, or a dusty burning smell
FAQ

Frequently asked questions

Don't see your question? Call (210) 898-9282.

What happens if I don't change my furnace filter?

Airflow drops, the furnace overheats and shuts off, the blower motor strains, and over time the heat exchanger can be damaged. It also raises energy bills.

Can I run my furnace without a filter?

Only for a very short time in an emergency. Without a filter, dust coats the blower, coil and heat exchanger, reducing efficiency and causing repairs.

Where is my furnace filter?

Usually in a return air grille on a wall or ceiling, or in a slot at the furnace or air handler. Some homes have several return grilles, each with its own filter.

Furnace down? Get your heat back today.

Licensed furnace repair in Schertz, TX, with a written price before work and 24/7 emergency service.

Call Now Free Estimate